Canon imageCLASS MF7470 - Manual (Page 137)

1
2
3
4
5
6
7
8
9
10
11
4-26
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
13. Press [Password].
14.
Enter a password (up to 24 characters when
[FTP] is selected as the server protocol, or up to
14 when [Windows (SMB)] is selected), then
press [OK].
If you are sending to an imageWARE Document Manager folder,
enter the password set in imageWARE Gateway.
15.
Press [OK].
Using the Browse Key (Windows (SMB))
1. Press (SEND).
2. Place your originals.
3. Make sure the machine is ready to send.
4.
Press [New Address].
5. Press [File].
6. Press the Protocol drop-down list, then select
[Windows (SMB)].
7. Press [Browse].
After turning the main power on, you must wait for the time set in
Startup Time Settings to elapse before pressing [Browse]. Network
transmission is not possible until this startup time has elapsed. (See
“Startup Time Settings,” on p. 6-45.)
8.
Select the desired workgroup, then press
[Down].
To move up one level, press [Up].
If the desired workgroup is not displayed, press [ ▼] or [▲] to scroll
to the desired workgroup.
9. Select the desired file server, then press [Down].
To move up one level, press [Up].
If the desired file server is not displayed, press [ ▼] or [▲] to scroll to
the desired file server.
If the Enter Network Password screen is displayed:
Press [User Name].
Enter your user name (up to 24 characters), then press [OK].
Press [Password].
Enter your network password (up to 14 characters), then press
[OK].
Press [OK].
10. Press [Down].
●
–
–
–
–
–