Canon imageCLASS MF7470 - Manual (Page 206)

1
2
3
4
5
6
7
8
9
10
11
6-5
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Basic Network Settings
Basic Network Settings are required in order to use the
following functions of the machine.
Printing or sending a fax from a computer
Using e-mail/I-fax
Sending data to a file server
Before making basic network settings, confirm that the
following procedures are performed.
It is recommended that the network administrator perform the following
procedures.
In a Windows network environment, the TCP/IP or NetBIOS (NetBIOS over
TCP/ IP) protocol can be used. Multiple protocols can be used at the same
time.
In addition to IPv4 (Internet Protocol Version 4), the machine also
supports IPv6 (Internet Protocol Version 6), and has a dual stack
configuration that enables it to communicate with both IPv4 networks
and IPv6 networks. The functions of IPv4 are always enabled, and you can
select whether to use the functions of IPv6.
If you want to use the machine in an IPv6 network, specify IPv6 settings.
(See “TCP/IP Settings (IPv6),” on p. 6-40.
To use the e-mail/I-fax function, the TCP/IP protocol is required.
IPv6 is not supported for sending e-mail/I-fax from the machine and for
sending jobs to a file server.
The machine works best in a Windows-only environment, but can be
used in a network of different operating systems as well, including
Windows, UNIX, Mac OS X, and Linux, depending on your usage needs.
(See “System Requirements,” on p. 6-3.)
1. Network Cable Connection (See “Set the
Machine for Network Usage (imageCLASS
MF7480/MF7470 Only),” in the Starter Guide.)
Connect the machine to your network using the network cables.
●
●
●
–
–
–
–
–
–
–
2.
Preparation for Protocol Settings (See “Set the
Machine for Network Usage (imageCLASS
MF7480/MF7470 Only),” in the Starter Guide.)
Specify the machine’s IP address so that the machine and the
network computer can communicate before making protocol
settings. Any of the following can be used to specify the settings.
Machine’s control panel (Additional Functions menu)
NetSpot Device Installer (Canon utility software included in the
User Software CD)
Interface Settings
Ethernet Driver
You can specify the communication method and Ethernet
connection type.
1.
Press (Additional Functions).
2. Press [System Settings] → [Network Settings] →
[Ethernet Driver Settings].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The Ethernet Driver Settings screen appears.
–
–
■