Canon imageCLASS MF7470 - Manual (Page 242)

1
2
3
4
5
6
7
8
9
10
11
6-41
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
1. Press (Additional Functions).
2.
Press [System Settings] → [Network Settings] →
[TCP/IP Settings] → [IPv6 Settings].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The IPv6 Settings screen appears.
3. Press [Use IPv6].
4.
Select [On] or [Off] for <Use IPv6>, then press
[OK].
[On]: Enables the use of IPv6.
[Off ]: Disables the use of IPv6.
If you press [On] for <Use IPv6>, a link local address is automatically
set.
5. Press [Stateless Address Settings].
6. Select [On] or [Off] for <Use Stateless Address>,
then press [OK].
[On]: Sets a stateless address automatically when the machine is
started.
[Off ]: Does not set a stateless address automatically.
The stateless address is discarded when the machine is restarted
(with the machine’s main power switch on).
7. Press [Manual Address Settings].
8.
Select [On] or [Off].
[On]: Enables you to set the IPv6 address manually. Proceed to step 9.
[Off ]: Disables you to set the IPv6 address manually. Skip to step 16.
9. Press [Settings].
10.
Press [Manual Address].
11. Enter the IPv6 address value using the keys on
the touch panel display, then press [OK].
12. Enter the IPv6 address prefix length in <Prefix
Length> using [-], [+], or – (numeric keys).
13. Press [Default Router Addr.].
14. Enter the default router address value using the
keys on the touch panel display, then press [OK].
15.
Confirm the settings you specified, then press
[OK].
16. Press [OK].
17. Press [Use DHCPv6].
18.
Select [On] or [Off] for <Use DHCPv6>, then
press [OK].
[On]: Uses DHCPv6 to obtain a stateful address from a DHCP server.
[Off ]: Does not obtain a stateful address from a DHCP server.
If you press [On] for <Use DHCPv6>, a stateful address is
automatically set.
19. Press [Done] repeatedly until the Additional
Functions screen closes.
20. Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.