Canon imageCLASS MF7470 - Manual (Page 246)

1
2
3
4
5
6
7
8
9
10
11
6-45
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
6. On the IP Address Range Settings screen, select
the IP address, the range of IP addresses, or
prefix address that is to be permitted or
rejected, then press [Permit/Reject].
[Permit]: Allows the access to the machine from the selected IP
address, the range of IP addresses, or prefix address.
[Reject]: Rejects the access to the machine from the selected IP
address, the range of IP addresses, or prefix address.
If you want to delete an IPv6 address or IPv6 address range,
select the address or address range on the IP Address Settings
screen, press [Erase], then press [Yes] to delete.
If you want to edit an IPv6 address or IPv6 address range, select
the address or address range on the IP Address Settings screen,
press [Edit], edit the address or address range in the same
manner as to register them, then press [OK].
7. Press [OK].
8. Press [Done] repeatedly until the Additional
Functions screen closes.
9.
Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.
HTTP Settings
You can restrict the use of Remote UI.
For the setting procedure, see “HTTP Settings,” on p. 6-38.
–
–
Port Number Settings
Depending on your network environment, you can change the port
number for each protocol.
For the setting procedure, see “Port Number Settings,” on p. 6-38.
Startup Time Settings
If you connect the machine to a switching hub, it may not be able
to connect to a network even though your network settings are set
correctly.
This occurs because the spanning tree process performed between
switching hubs prevents them from communicating with each
other immediately after the machine connects to a switching hub.
In this case, use the following procedure to delay the startup of
network communication.
1.
Press (Additional Functions).
2. Press [System Settings] → [Network Settings] →
[ ▼] → [Startup Time Settings].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The Startup Time Settings screen appears.
3. Set the time period (0 to 300 seconds) required
to delay the startup of network communications
for the machine.
Press [-], [+] or – (numeric keys) to set the time period.
You can enter the value from 0 to 300 (seconds).
4. Press [OK].
■