Canon imageCLASS MF7470 - Manual (Page 299)

1
2
3
4
5
6
7
8
9
10
11
8-17
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Restricting the New Address
This mode enables you to restrict the entering of new destinations.
When you set Restrict New Addresses to [On], the following are
restricted:
Specifying a destination using the numeric keys.
Changing registered destinations.
Registering new destinations.
1. Press (Additional Functions).
2. Press [System Settings] → [ ▼] → [Restrict the
Send Function] → [Restrict New Addresses].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The Restrict New Addresses screen appears.
3. Select [On] or [Off], then press [OK].
4. Press [Done] repeatedly until the Send Basic
Features screen appears.
■
–
–
–
Setting Whether to Allow Sending Using
the Fax Driver
You can specify whether or not to allow sending faxes from
computers using the fax driver.
1. Press (Additional Functions).
2. Press [System Settings] → [ ▼] → [Restrict the
Send Function] → [Allow Fax Driver TX].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The Allow Fax Driver TX screen appears.
3. Select [On] or [Off], then press [OK].
[On]: The machine can send documents via the fax driver.
[Off ]: The machine cannot send documents via the fax driver.
4. Press [Done] repeatedly until the Send Basic
Features screen appears.
■