Canon imageCLASS MF7470 - Manual (Page 359)

1
2
3
4
5
6
7
8
9
10
11
10-29
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Service Call Messages
If a malfunction occurs and the machine cannot operate
normally, a screen like the one shown below is displayed.
Follow the instructions that appear on the touch panel display.
If a message like the one shown below appears, follow the
procedure described below.
Do not connect or disconnect the power cord with wet hands, as this may
result in electrical shock.
Always grasp the power plug portion when disconnecting the power cord.
Pulling on the power cord may expose or snap the core wire, or otherwise
damage the power cord. If the power cord is damaged, this could cause an
electricity leak and result in a fire or electrical shock.
Sending or receiving documents cannot be done when the main power
switch is off.
If the main power switch is turned off, all jobs waiting in the print queue
will be erased.
Documents received into memory and documents stored for delayed
send will be retained for approximately 60 minutes after the power cord
has been disconnected. –
–
–
1. Turn the main power switch off. Allow at least 10
seconds before turning the main power switch
back on.