Canon imageCLASS MF7470 - Manual (Page 68)

1
2
3
4
5
6
7
8
9
10
11
2-20
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
If you want to select a nonstandard paper size:
Press [Irreg. Size].
Press [X] to specify the horizontal axis of the paper, then enter a
value using the numeric keys on the touch panel display.
Press [Y] to specify the vertical axis of the paper, then enter a
value using the numeric keys on the touch panel display.
Press [OK].
If you make a mistake when entering values, press [C] on the
touch panel display, then enter the correct values.
You can enter only 2, 4, 8 or 16 as the denominator.
The value entered in inches is converted to millimeters by the
machine each time it is entered. Thus, there may be a slight
difference between the value calculated and the actual value
entered.
To enter values in millimeters, press [mm].
When entering the value in millimeters, you can also use
–
(numeric keys), and (Clear) to clear your entry.
When entering the value in millimeters, you can also change the
value by pressing [-] or [+] in increments of 1.0 mm, even if you
have entered the value.
If you enter a value outside the setting range, [OK] is grayed out
and cannot be selected. Enter an appropriate value.
You can use values for [X] between 5 7/8" (148 mm) and 17" (432
mm), and for [Y] between 3 3/4" (95 mm) and 11 11/16" (297
mm).
●
–
–
–
–
–
–
–
–
–
–
–
–
Press [Next]
Select the desired paper type, then press [OK].
When printing on special types of paper, such as heavyweight
paper, be sure to correctly set the paper type, especially if you are
using heavyweight paper. If the type of paper is not set correctly,
it could adversely affect the quality of the image. Moreover, the
fixing unit may become dirty and require a service repair, or the
paper could jam.
If you select [Irreg. Size], you cannot use the 1
▶ 2-Sided, 2 ▶
2-Sided, or Book ▶ 2-Sided mode.
If you want to select an envelope size:
Press [Envelope].
Select the envelope type, then press [OK].
If the envelope type is not selected correctly, a paper jam may
occur.
If you select [Envelope], you cannot use the 1
▶ 2-Sided, 2
▶ 2-Sided, Book ▶ 2-Sided, 2-page Separation, or Image
Combination mode.
Press [OK].
[Transparency] can be selected only if [LTR] is selected as the paper
size.
5. Press [OK].
6. Press [Done] repeatedly until the Basic Features
screen appears.
–
–
–
–
●
–
–
–
–
–