Canon imageCLASS MF7470 - Manual (Page 77)

1
2
3
4
5
6
7
8
9
10
11
3-6
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Manual Paper Selection
You can make copies after manually selecting the paper size and
type of paper loaded in the paper sources.
You can copy an image onto envelopes, such as your company logo.
Envelopes can be loaded into the stack bypass.
1. Press (COPY).
2. Place your originals.
If you want to set the size/type for the paper to be fed from the stack
bypass, proceed to step 5.
If you want to set the size/type for the paper loaded in a paper
drawer, proceed to step 3.
3. Press [Paper Select].
When the feeder is closed, the paper source holding that paper size
is highlighted along with [Auto].
4.
Select the desired paper size, then proceed to
step 7.
The paper sizes/types loaded in each paper drawer are indicated
by icons on the touch panel display.
Icons indicating the type of paper loaded in each paper drawer
can be displayed on paper select screens, if you store that
information in the machine beforehand. (See “Changing/
Canceling Selected Settings,” on p. 3-36.)
indicates that the paper is loaded vertically, and indicates
that the paper is loaded horizontally. The suffix <R> (such as in
LTRR), used in paper size designations, indicates that the paper is
loaded in a paper drawer or the stack bypass horizontally.
■
–
–
–
5. For the stack bypass setting, load the paper into
the stack bypass.
The paper size/type setting in the [Stack Bypass] setting screen is
available if Stack Bypass Standard Settings is set to [Off ] in Common
Settings (from the Additional Functions screen). If Stack Bypass
Standard Settings is set to [On], copying can be performed only for
the registered paper size and type. (See “Stack Bypass Standard
Settings,” on p. 11-7.)
If you want to select a standard paper size:
Select the desired paper size, then press [Next].
To select an A or B series paper size, press [A/B-size].
Select the desired paper type, then press [OK].
When printing on special types of paper, such as heavy paper
or transparencies, be sure to correctly set the paper type,
especially if you are using heavy paper. If the type of paper is
not set correctly, it could adversely affect the quality of the
image. Moreover, the fixing unit may become dirty and require
a service repair, or the paper could jam.
If you select [Transparency] or [Labels], make sure that you do
not specify any Finishing modes (Collate or Group).
[Transparency] can be selected only if [LTR] is selected as the
paper size.
[3-hole punch] can be selected only if [LTR] or [LTRR] is
selected as the paper size.
●
–
–
–
–
–
–