Canon imageCLASS MF7470 - Manual (Page 84)

1
2
3
4
5
6
7
8
9
10
11
3-13
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Reserved Copy
You can set the machine to scan originals even while it is
printing or waiting to process a job.
You can reserve up to five copy jobs, including the current job.
You can set different copy modes and paper sources for each reserved
job.
Reserving Copy Jobs
Reserved printing can be specified in the following cases:
While the Machine Is Waiting
You can specify copy settings or scan originals while the machine is
in the waiting state, such as when after a paper jam is cleared.
Copying automatically begins when the machine is ready. The
message <Reservation copies can be made.> appears on the touch
panel display when the machine is able to process reserved
copying.
While the Machine Is Printing
You can specify copy settings for a new job while the machine is
printing. Copying of the new job automatically begins when the
current job is complete.
You can specify reserved copying while the machine is in the waiting state
in the following cases:
After a paper jam is cleared
After a cover on the main unit is opened and closed
–
–
■
●
●
–
–
1. Press [Done] on the pop-up screen that appears
while the machine is printing.
If the job displayed on the touch panel display is from a function
other than the Copy function, press [Done] , then
(COPY) to
display the Copy Basic Features screen.
This part of the procedure is not necessary if the machine is in the
waiting state.
2. Place your originals.
3.
Set the desired copy modes and paper source.
To cancel a previously set copy mode, press (Reset).
4. Press (Start).
If you specify a reserved copy job while the machine is in the waiting
state, copying automatically begins when the machine is ready.
If you specify a reserved copy job while the machine is printing,
copying of the new job automatically begins when the current job is
complete. If the following screen is displayed, press [OK], then try
reserving the job again after the current job is complete.