Canon imageCLASS MF7470 - Manual (Page 95)

1
2
3
4
5
6
7
8
9
10
11
3-24
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
7. Select the desired paper size, press [OK], then
[Done].
You cannot use Automatic Paper Selection in the Image
Combination mode.
The machine automatically selects the copy ratio depending on
the selected paper size.
The most suitable image orientation for the specified paper size
is automatically determined even if Auto Orientation is set to
[Off ]. (See “Auto Orientation,” on p. 11-9.)
8. Press (Start).
If the original is placed on the platen glass, follow the instructions
that appear on the touch panel display ,then press (Start) once for
each original. When scanning is complete, press [Done].
To cancel this setting, press [Special Features] → [Image
Combination] → [Cancel].
To cancel all settings and return the machine to the Standard
mode, press (Reset).
–
–
–
–
–
Frame Erase
This mode enables you to erase shadows and lines that appear
when copying various types of originals. The following three
Frame Erase modes are available.
Combinations of the three Frame Erase modes cannot be set. If you select
one of these modes, the previously set mode is canceled.
Original Frame Erase
This mode erases the dark borders and frame lines that appear
around the copy if the original is smaller than the selected paper
size. You can also use this mode to create a blank border around the
edge of the copy.
Original (STMT)
Original Frame
Erase Selected
Original Frame
Erase Not Selected
Copy (LTR)
Copy (LTR)
■
●