Canon Wireless Transmitter WFT-E6A - Manual (Page 32)

32
Automatic Image Transfer After Each Shot
To transfer smaller JPEGs when the camera is set up to record larger JPEGs to one card
and smaller JPEGs to the other, set [JPEG size to trans.] to [Smaller JPEG].
To transfer either RAW or JPEG images when the camera is set up to record RAW images
to one card and JPEGs to the other, specify which images to transfer in the [RAW+JPEG
transfer] setting. Similarly, complete the same setting when RAW+JPEG images are
recorded simultaneously to a single memory card.
When images of the same size are recorded to both cards simultaneously, images recorded
to card 1 are transferred, regardless of image quality (compression).
If transfer fails, the <Y> lamp on the camera
blinks in red. In this case, press the <7> button,
select [Communication settings] on the [53] tab,
and press <0>. When the screen shown on the left
is displayed, check the error number and see page 98
to eliminate the cause of the error.
Once the cause of the error is eliminated, the images
whose transfer previously failed will be transferred automatically. With this option activated,
transfer is attempted again automatically after failure, whether when automatic transfer is used
or when transferring captured images via FTP. Note that when you cancel image transfer, or
turn off the camera, the image will not be re-transferred automatically. See page 36 and transfer
the image manually.
In the menu, select [Communication settings]  [Network settings]  [Set up] 
[LAN power save].
When this option is set to [Enable], the transmitter will log off from the FTP server after
transfer and switch to standby mode. Wireless connectivity will be restored automatically
when you attempt to transfer images, and the transmitter will reconnect to the FTP server.
Auto Retry if Transfer Fails
Enabling LAN Power Management
COP
Y