Canon Color imageCLASS MF9220Cdn - Manual (Page 38)

36
1 Settings Necessary to Use the Machines Functions
If you need to manually enter a static IP address (even when the machine is set to obtain an IP address
automatically), follow the procedure below. Configure the setting for the IP address manually in the User
Mode after finishing the “Setup Guide.”
In this setting, enter the IP address, subnet mask, and gateway address manually.
Press
(Main Menu) → <Additional Func.> → <System Management Set.>* → <Network Settings> →
<Done> → <TCP/IP Settings> → <IPv4 Settings> → <IP Address Settings> → <Manual Settings> → Enter the
IP address → Enter the subnet mask → Enter the gateway address → (Main Menu) to return to the
Main Menu screen. → Turn OFF the main power → Restart the machine.
* If the screen appears prompting you to enter the System Manager ID and System Password, enter the
System Manager ID and System Password using - (numeric keys), then press (Log In/Out). For
details, see “Security,” in the e-Manual.
For more information on this setting, see “Network Settings,” in the e-Manual.
Set IP Address Manually
Finish “Setup Guide”
All the settings with the “Setup Guide” are complete. Follow the procedure below to finish the “Setup Guide.”
After finishing the “Setup Guide,” you need to set up the computer and software for the machine.
1
Make sure the following screen is displayed on
the display, then press [ OK ] to proceed to the
“Setup Guide.”
Make sure the USB cable is not connected to the machine. If
it is connected already, disconnect it from the machine.
2
Press [ OK ] to finish the “Setup Guide.”