Canon Wireless File Transmitter WFT-E2 II A - Manual (Page 82)

82
Responding to Error Messages
What to check on the transmitter
Is the transmitter configured for communication in infrastructure mode?
X Configure the transmitter for communication in ad hoc mode.
What to check on the wireless LAN device
Is there a nearby wireless LAN device for ad hoc communication?
X Prepare a wireless LAN device for ad hoc communication near the transmitter.
Are the transmitter and wireless LAN device configured for the same
authentication method?
X The transmitter supports these authentication methods: [Open system], [Shared key],
[WPA-PSK], and [WPA2-PSK]. (p.16)
X When using an AirPort for communication in infrastructure mode, [Open system] is not
supported. Configure a [Shared key] on the transmitter. (p.16)
Are the transmitter and wireless LAN device configured with the same encryption
key for authentication?
X The setting is case-sensitive, so check upper- and lower-case characters. Make sure the
correct encryption key for authentication is entered on the transmitter and wireless LAN
device. (p.17)
If you are filtering by MAC address, did you register the transmitter’s MAC address
on the wireless LAN device?
X Register the transmitter’s MAC address (p.50) on the wireless LAN device.
Are the transmitter and wireless LAN device configured for the same encryption
method?
X The transmitter supports these encryption methods: [WEP], [TKIP], and [AES]. (p.16)
If you are filtering by MAC address, did you register the transmitter’s MAC address
on the wireless LAN device?
X Register the transmitter’s MAC address (p.50) on the wireless LAN device.
62: No response from wireless LAN terminal
63: Wireless LAN authentication failed
64: Cannot connect to wireless LAN terminal
COP
Y