Step 4 turning the power on – Canon imageFORMULA DR-M140 Document Scanner User Manual

Page 15

Advertising
background image

15

S

e

tup Guide

STEP 4

Turning the Power ON

The power of the scanner can be turned ON and OFF with the power
button on the front of the scanner.

1

Make sure that the scanner and computer are connected
properly.

2

Press the power button.

The power button lights blue when the power turns ON.

Hint

A balloon message such as shown below appears on the task bar. If
you wait a while, automatic scanner recognition will end and the
scanner will become ready to use.

Ð

When the scanner is properly connected to the computer, the

(CaptureOnTouch) icon appears on the taskbar as follows.

If the taskbar icon appears as

, the scanner is not properly

connected to the computer. Check the status of the power switch and
USB cable.

Turning Off the Power

Press and hold the power button until the indicator goes out.

IMPORTANT

• After turning the scanner off, wait at least 10 seconds before turning

it back on.

• If you will not be using the scanner for an extended period, you

should disconnect the power cord from the AC outlet for safety.

Hint

The scanner’s auto power off setting is enabled by default, and the
scanner will turn off automatically if it is not operated for 4 hours.
For details on how to disable this setting, see “Auto Power Off Setting”
on p. 47.

Power button

This completes setup.

0-00-DR-M140_RG_UK.book Page 15 Monday, August 8, 2011 5:15 PM

Advertising