Canon imagePROGRAF iPF750 MFP M40 - Manual (Page 725)

Specifying the Printer's Frame Type
To enable communication between the printer and computers on your network, specify the Ethernet frame type in your Net-
Ware environment.
Follow the steps below to specify the frame type by using imagePROGRAF Device Setup Utility or the printer Control
Panel.
Important
• Before specifying the frame type, make sure the printer is on and connected to the network.
Note
• You can specify the frame type by using RemoteUI if the printer's IP address is configured.
• For instructions on installing imagePROGRAF Device Setup Utility, see "Installing imagePROGRAF De-
vice Setup Utility." →P.407 .
Specifying the frame type using imagePROGRAF Device Setup Utility
1.
Start imagePROGRAF Device Setup Utility.
2.
In the list of printers, select the printer to configure.
3.
Choose Protocol Settings from the Printer menu.
Network Setting > NetWare Settings >
iPF750 Specifying the Printer's Frame Type
9
709