Canon imagePROGRAF iPF750 MFP M40 - Manual (Page 815)

HP-GL/2 problems
With HP-GL/2, printing is misaligned .............................................................................................................. 799
Lines or images are missing in printed HP-GL/2 jobs. ................................................................................... 799
Lines are printed too thick or thin in HP-GL/2 print jobs ................................................................................. 799
HP-GL/2 jobs are printed in monochrome (or color) ...................................................................................... 800
Printed colors of lines are inaccurate during HP-GL/2 printing ...................................................................... 800
HP-GL/2 jobs are printed 6 mm larger than specified .................................................................................... 800
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified .......................................... 800
HP-GL/2 printing takes a long time ................................................................................................................. 800
Replotting with HP-GL/2 jobs is not possible. ................................................................................................. 801
The printer stops when printing a HP-GL/2 job (the carriage stops moving) ................................................. 801
With HP-GL/2, printing is misaligned
Cause Corrective Action
The plotter origin is incorrect. Check the printing commands.
The Margin setting in the Control Panel menu is incor-
rect. Adjust the Margin setting values in the Control Panel
menu.
Lines or images are missing in printed HP-GL/2 jobs.
Cause Corrective Action
The memory is full. Check the size of the data in the print job.
An HP-GL/2 command not supported by this printer was re-
ceived. Check the print job and settings.
The printer has received print data that includes HP RTL com-
mands when Auto Rotate is On in the Control Panel menu. In the Control Panel, set Auto Rotate to Off and
print again.
(See "Menu Settings.")
→P.673
Lines are printed too thick or thin in HP-GL/2 print jobs
Cause Corrective Action
The Width setting in the
Control Panel menu is in-
correct. Check the Width setting value specified for Pen no. in Palette A or Palette B in the
Control Panel menu. If fine lines are printed faintly, setting ThickenFineLines to On
will print the lines more distinctly.
(See "Menu Settings.")
→P.673
Troubleshooting > HP-GL/2 problems >
iPF750 With HP-GL/2, printing is misaligned
11
799