Canon imagePROGRAF iPF510 - Manual (Page 702)

Messages regarding paper
Can’t DetectPapr
Cause Corrective Action
The paper has come out of the printer. Remove the paper that has come out of the printer,
press the Online button, and reload the paper.
(→P.82)
(→P.89)
A paper jam occurred in the printer. Remove the jammed paper, press the Online button,
and reload paper.
(→P.122)
(→P.174)
(→P.169)
The roll cannot be correctly detected. Rewind the roll manually until the paper caught in
the rollers is completely out of the rollers. Press the
Online button and reload the roll.
Cutting Error
Cause Corrective Action
There are sheets left on the Output Tray. Remove the paper.
There is a foreign object by the Output Tray,
obstructing the Cutter Unit. Remove the foreign object.
You are not using the printer under the recommended
environmental conditions for the paper. Use the printer only where the recommended
environmental conditions for the paper are met.
Note that various environmental conditions are
recommended for various types of paper. For details
on the recommended environmental conditions for
paper, see “Types of Paper”. (→P.103)
You are using paper that is not compatible with
automatic cutting. Cut the roll manually.
(→P.131)
The Cutter Unit stops in the middle of cutting. Move the Cutter Unit to the left, and then remove the
roll paper. If the roll cannot be cut using the Cutter
Unit, cut the roll manually.
(→P.131)
In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance.
Feed Limit..
Cause Corrective Action
You are pressing the ▲ button on the Control Panel
and trying to rewind the roll completely. Release ▲.
688 Error Message