Canon TX-20 Full Auto Tonometer - Manual (Page 67)

5TypesofMeasurements
67
Settings for Patient No.
You can set patient No., patient No. display, patient No. count up, output at measurement error, reset,
in the Patient No. menu screen.
The patient No. is a number to identify patients. You can set any number from 000001 to 999999
and you can set the number to increase by one each time a measurement is done. Patient No. can
be checked on the Measurement screen, MENU screen, printed data, and data output to external
devices.
How to Enter the Patient No. Menu
MENU screen > Patient tab > [Patient No.]
Setting items Description
Factory
settings
Display Set the display of the patient No. on the Measurement screen and
whether to increase the numbers in series.
Increase the number after measurement when the PRINT button or the
CLS key is pressed.
[ON]: Displays. Numbers increase serially.
[OFF]: Does not display. Numbers do not increase serially.
ON
Count up on
Error Set whether to increase the patient number serially even if the
measurement results are just an error.
[ON]: The patient No. increases serially.
[OFF]: The patient No. does not increase serially.
ON
No. Set the patient No.
[000001 to 999999]: Six-digit number 1
Reset No. Set the patient No. to “000001”. For this setting, press the measurement
button to display the message screen and you can select reset.
[OK]: Resets.
[CANCEL]: Does not reset.
L-IE-5191C_TX-20.indb 67 2013/07/18 13:10:37