Canon TX-20 Full Auto Tonometer - Manual (Page 75)

6Maintenance
75
2
Remove the remaining paper.
Remove the old roll of paper.
CAUTION Do not touch the cutter for the printer
Do not touch the cutter for the printer. Similarly, instruct the patient not to touch the cutter for the
printer.
Otherwise, it may result in injury.
3
Put new paper into the printer.
Load the roll of paper into the printer as illustrated.
Be sure to check that the direction of roll is the same as shown
in the illustration.
CAUTION Print quality, thermal head service life, cutting operations, and auto cutter service life may not be
guaranteed if thermal paper not specified by Canon is used. Always use thermal paper specified
by Canon.
4
Set the printing paper.
Pull out about 5 cm of the leading edge of the paper through
the paper slot while the paper cover is open. Set the printing
paper straight so it does not skew.
5
Close the paper cover.
When the paper is set correctly, close the paper cover until it is
in the lock position. The paper automatically feeds and is cut.
CAUTION After closing the paper cover, do not pull the thermal paper out before the paper is cut
automatically. There is a risk of damaging the printer.
If the paper is fed through the printer incorrectly, it may cause a paper jam. If the paper jams, open
the paper cover and adjust the paper so it feeds correctly.
L-IE-5191C_TX-20.indb 75 2013/07/18 13:10:40