American Audio CDI-300 - Manual (Page 20)

BASIC OPERATIONS (CONT.)
Figure 27
© American Audio ® - www.AmericanAudio.us - CDI-300™ Instruction Manual Page 20
13. BANK BUTTONS (4):
These buttons are used to store your samples and cue points. Only a sample
or a cue point can be stored into each of these three banks. When a sample is
stored in to these banks you may use the sample starting point as a cue point.
The BANK BUTTONS instantly recall and play any of your stored samples or
cue points without interrupting music playback. When in sample mode, (see
"Using the Built-In Sampler" on page 19) and during playback, pressing any of
the BANK BUTTONS that stores a sample, will immediately begin to play that
sample without interruption of music. If the unit is in sample mode and the drive
is not in playback mode, pressing any of the BANK BUTTONS that stores a
sample, will immediately begin to play that sample.
14. CHANGING THE TIME DISPLAY (35, 36, & 37)/TIME BAR (34):
DURING NORMAL PLAYBACK, pressing the TIME BUTTON (6), will change the
time display information (35, 36, 37, & 34) in the LCD (22). The following is a break
down of the time settings and their definitions:
1)
ELAPSED - This describes the time in the LCD (35, 36, & 37) as the current
TRACKS Elapse running time.
2)
REMAIN (38) - This describes the time in the LCD (35, 36, & 37) as the
current TRACKS remaining running time.
3)
TOTAL REMAIN (39) - This describes the time in the LCD (35, 36, & 37) as
the disc total remaining running time.
TIME BAR INDICATOR - Details the time defined in the TIME METER (35, 36, & 37) as a visual bar icon. As
with the TIME METER (35, 36, & 37) this bar is also dependent on the selected time function [TOTAL REMAIN
(39), REMAIN (38) OR ELAPSED]. This bar will begin to flash when a track is ending regardless
of which time
func t
i
on you are in. Use the flashing bar as a visual reminder that a track is ending.
Figure 28
� � � � � � � � � � � � � � � � � � � �
� � � � � � � � � � � � � � � � � � � �