Bosch WAP24202UC - Manual (Page 13)

13
▯
Make sure the water supply faucet is easily accessible
when the washer is in use. The faucet should be
turned off if the washer is going to be unused for
extended periods of time.
▯
Make sure rubber washers are in place at both ends of
the water supply hose. Missing washers could cause
leaks.
▯
The connection points are under full water pressure.
Turn on the water tap and check for leaks.
▯
Periodically inspect the water supply hose and replace
with a new hose if cuts, kinks or leaks are observed.
Water connection hoses
▯
red - Hot water-hose
▯
blue - Cold water-hose
Attach this end to water tap. Hand tighten only.
Attach this end of the hose to the back of the washing
machine. Hand tighten only.
About the AquaShield Hose
The AquaShield hose prevents potential flooding in the
event the hose develops an internal leak. If the hose
leaks, the indicator turns red and water flow is blocked.
Water drain hose connection
NOTICES
▯
Do not reuse an old drain hose. Only use the drain
hose and parts included with your washer.
▯
Do not kink or modify the water drain hose.
Height of drain point
Height difference between the floor and drainage point:
max. 39 in. (100 cm).
Types of drainage hookups
Standpipe
Attach the drain hose using the elbow included with your
washer.
Fit the drain hose to the elbow provided leaving a
maximum of 4 inches of drain hose projecting. Insert this
section of the drain hose into the drain pipe. Secure the
elbow and hose with a nylon tie strap or the equivalent to
keep the hose from coming out of the drain pipe during
use.
Sink siphon
Secure the drain hose to the sink siphon using a Ø 0.9 -
1.6 in. (20-44 mm) hose clip (available from a hardware
store).
PD[ ƒ PD[ ƒ
LQ
FDEOHWLH
GUDLQ
SLSH