Bosch WTB86201UC - Manual (Page 21)

21
Program settings
At the factory initial settings are pre-set for all cycles.
You can change some program settings as follows.
Time Dry
Available only for Time programs,
~ Program selection table; Page 20
can be selected from minimum 20 minutes to maximum
3 hours, in 10-minute steps.
Dry Level
The dryness levels (e.g. Cotton Dry) can be increased in
3 levels. The laundry is made drier.
Default setting = 0.
Selectable values: 0, 1, 2, 3.
After setting the Dry Level for a program, it is also
retained for other programs, until it is changed again.
Finished in
Before the program start, the program end (Finished in
time) can be pre-selected in one-hour steps up to a
maximum of 24 h (h=hour).
Press the Finished in button until the desired setting is
displayed.
NOTICE: The cycle duration is included in the set
Finished in time.
After the start, the pre-selected drying time, e.g. 8 h is
displayed and counted down until the drying cycle
begins. Then the cycle duration, e.g. 2:30
(hours:minutes) is displayed.
Additional options
Low Heat
Reduced temperature for delicate fabrics, e.g.
polyacrylic, polyamide or elastane, with longer drying
time.
Observe the care information or symbols on the textiles
tickets.
Wrinkle Block
To prevent the laundry from creasing, the dryer drum
rotates at specific intervals following the drying program.
Standard setting for this function is 1 hour.
If the Wrinkle Block button is pressed, this function is
extended to 2 hours.
The laundry remains loose and fluffy until it is removed.
The laundry should be removed at the latest after this
time has elapsed.