Close the filter and re-insert it, Close the door, Notice – Bosch WTB86201UC User Manual
Page 28: Cleaning the heat exchanger, Unlock the maintanance flap and open it completely, Turn both locking levers towards each other, Pull out the heat exchanger cap, Remove the heat exchanger
28
6.
Close the filter and re-insert it.
7.
Close the door.
NOTICE: The filter should be rinsed once a year under
warm running water.
The filter must be dried thoroughly before being
replaced.
Cleaning the heat exchanger
The heat exchanger requires periodic cleaning
(recommended once per month under normal drying
conditions). The frequency of cleaning depends on the
amount and type loads being dried.
To clean the heat exchanger:
1.
If the dryer is hot, run on Air fluff/No heat program to
allow the dryer to cool down.
2.
Residual water may escape, place an absorbent cloth
under the maintanance flap.
3.
Unlock the maintanance flap and open it completely.
4.
Turn both locking levers towards each other.
5.
Pull out the heat exchanger cap.
6.
Remove the heat exchanger.
NOTICE: Do not damage the heat exchanger! Clean
with warm water only. Do not use hard/sharp-edged
objects!
7.
Rinse the heat exchanger and the cap on all sides with
a jet of water to completely remove all of the fluff.