Connecting the appliance, Electrical connection, Warning – Bosch B11CB50SSS User Manual

Page 6: Avoid the risk of an electric shock

Advertising
background image

en-us

6

Connecting the appliance

After installing the appliance, wait at least 1 hour until

the appliance starts up. During transportation the oil in

the compressor may have flowed into the refrigeration

system.
Before switching on the appliance for the first time,

clean the interior of the appliance (see chapter

“Cleaning the appliance”).

Electrical connection

,

WARNING:
Avoid the risk of an electric shock!

,

WARNING:
Insert into a grounded 3-phase socket. Never

remove grounding phase. Do not use any

adapters. Do not use any extension cables.

,

WARNING:
Non-compliance with these instructions may

result in death, fire or an electric shock.

Improper connection of the protective conductor

may result in an electric shock. If you are in

doubt whether the appliance has been grounded

properly, have the appliance tested by

a qualified electrician or service technician.

Do not use extension cables or distributors. This

appliance must be connected to a permanently

installed socket.

The socket must be near the appliance and also freely

accessible following installation of the appliance.
The appliance complies with protection class I.

Connect the appliance to 115 V/60 Hz alternating

current via a correctly installed socket with protective

conductor. The socket must be fused with a 10 to 16 A

fuse.
The appliance comes with a UL registered 3-wire power

cord. The appliance requires a 3-pole socket.
Please observe the following table with regard to this:

Check on the rating plate whether the indicated voltage

and current type correspond with the values of your

power supply. The location of the rating plate can be

found in the chapter entitled Customer service.

,

WARNING:
Never connect the appliance to electronic

energy saver plugs.
Our appliances can be used with mains and

sine-controlled inverters. Mains-controlled

inverters are used for photovoltaic systems

which are connected directly to the national grid.

Sine-controlled inverters must be used for

isolated applications (e.g. on ships or

in mountain lodges) which are not connected

directly to the national grid.

Appliance

Maximum simultaneous load

Fridge-freezer

6.0 amps

Advertising