Allied Air Enterprises 506271-01 - Manual

506271-01 Page 1 of 14 Issue 0921
Save these instructions for future reference
INSTALLATION INSTRUCTIONS
RPGE/RGE Series
Gas Heating/Electric Cooling Package Unit
Do not store combustible materials, including gasoline
and other flammable vapors and liquids, near the furnace,
vent pipe, or warm air ducts. Such actions could cause
property damage, personal injury, or death.
WARNING
Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage.
Refer to this manual. For assistance or additional information, consult a qualified installer, service agency,
or the gas supplier.
WARNING
Never use a flame to check for gas leaks. Explosion
causing injury or death may occur.
WARNING
If this unit is to be installed in a mobile or manufactured
home application, the ductwork must be sized to achieve
static pressures within the manufacturer’s guidelines. All
other installation guidelines must also be followed. Failure
to do so may result in equipment damage, personal injury,
and improper performance of the unit.
WARNING
The installation of the furnace, wiring, warm air ducts, venting, etc. must conform to the requirements of the National Fire
Protection Association; the National Fuel Gas Code, ANSI Z223.1 (latest edition) and the National Electrical Code, ANSI/
NFPA No. 70 (latest edition) in the United States; the Canadian Installation Codes CAN/CGA-B149.1 & .2 (latest edition)
and the Canadian Electrical Code Part 1, CSA 22.1 (latest edition) in Canada; and any state or provincial laws, local
ordinances, or local gas utility requirements. Local authorities having jurisdiction should be consulted before installation
is made. Such applicable regulations or requirements take precedence over the general instructions in this manual.
CAUTION
Manufactured By
Allied Air Enterprises, Inc.
A Lennox International Company
215 Metropolitan Drive
West Columbia, SC 29170
TABLE OF CONTENTS
INSTALLATION ...................................... 2
START-UP .............................................. 8
OPERATION ........................................ 10
Cooling System ............................... 10
Heating System............................... 10
MAINTENANCE .................................... 11
CONTROL SYSTEM DIAGNOSTICS .. 12
WIRING DIAGRAM .............................. 13
*506271-01*