Allied Telesis RAPIER I - Manual (Page 126)

126 QoS Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
To enable QoS counters, use the command:
set switch enhancedmode=qoscounters
To reset traffic class counters for a port group, use the command:
reset qos portgroup counters
trafficlass[={trafficclass-list|all}]
To display information about port groups, use the commands:
show qos portgroup
show qos portgroup counters
show qos port
Command Changes
The following table summarises the new and modified commands:
Storm protection
This Software Version includes an enhancement to Quality of Service (QoS)
that allows storm protection.
Storm protection uses QoS mechanisms to classify on traffic likely to cause a
packet storm (broadcast and multicast). With a per-port storm protection
mechanism, any traffic over the configured limit is discarded. However, with
QoS storm protection, several actions are possible when a storm is detected:
■ You can disable the port physically.
■ You can disable the port logically.
■ You can disable the port for a particular VLAN.
Enhanced mode must be enabled with the set switch enhancedmode
command in the Switching chapter before you can configure storm protection.
When a storm is detected on a port, a message is automatically recorded in the
log, and you can configure an SNMP trap to signal that a port has been
disabled. When a storm is detected on a trunk or port group, the entire trunk or
port group is disabled.
Command Change
add qos portgroup port New command
create qos policy New command
delete qos portgroup port New command
destroy qos portgroup New command
reset qos portgroup counters New command
set qos portgroup New command
show qos portgroup New command
show qos portgroup counters New command
show qos policy New Ports Assigned to parameter
New Port Groups assigned to parameter
show qos port New Port Group parameter
New Trunk Group parameter