Allied Telesis RAPIER I - Manual (Page 34)

34 Switching Enhancements Release Note
Software Version 2.8.1
C613-10477-00 REV B
disable switch debug
Syntax DISable SWItch DEBug={ARL|DEV|DMA|PHY|ALL}
Description The m6 parameter is now replaced by the dev parameter in this command.
disable switch filter vlansecure
Syntax DISable SWItch FILter VLANSecure
Description This new command modifies Layer 2 switch filtering by disabling vlansecure
mode. The vlansecure mode is enabled by default.
When vlansecure mode is disabled and a filter exists for a given host and port,
moving the host to a different port in the same VLAN only stops the host from
accessing that VLAN, not other VLANs. When vlansecure mode is enabled
and a filter exists for a given host and port, moving the host to a different port
blocks the host completely.
Example To turn off the default filtering behaviour, use the command:
dis swi fil vlan
disable switch port vlan
Syntax DISable SWItch POrt={port-list|ALL}
VLAN[={vlan-name|1..4094|ALL}]
where:
■ port-list is a port number, range (specified as n-m), or comma-separated list
of numbers and/or ranges. Port numbers start at 1 and end at m, where m
is the highest numbered Ethernet switch port, including uplink ports.
■ vlan-name is a unique name from 1 to 32 characters. Valid characters are
uppercase and lowercase letters, digits, the underscore, and hyphen.
Description This new command disables one or more ports from VLANs to which they
belong. Once disabled, a port remains a member of the VLAN, but does not
receive or transmit packets from that VLAN.
The port parameter specifies the port or ports to disable. If a trunked port is
specified, all ports in the trunk are disabled. When a VLAN is disabled on a
port, ingress filtering is automatically enabled for that port
The vlan parameter specifies the VLAN or VLANs for which ports are
disabled. Specified ports must be a member of the VLAN. If no value, or all is
specified, the specified ports will be disabled for all VLANs to which they
belong.
Debug Option Description
DEV Debugging occurs on operations related to the switch chip.