Hippo Wireless Stereo Headphones for Mobile Professionals - Manual (Page 13)

Listening to Music
Step 1: Turn ON your iWiSH Headphones
1. Ensure that the headphones are fully charged.
2. Press the Multifunction Button for 2 seconds to turn ON the headphones. You will see
the Power LED (Red) glow for a brief while and you will hear a startup tune on the
headphones. Release the button once the Power LED turns OFF. The headphones are
now ready to accept Bluetooth connection from the USB sound stick. The Activity LED
(Blue) glows continuously to indicate readiness.
Note : To preserve battery charge, the headphones automatically turn off after 3 minutes
if there is no Bluetooth connection from the sound stick.
Step 2: Set up USB Sound Stick on PC or Mac
1. Identify a free USB slot on your PC/Mac and plug in the USB sound stick.
2. Wait a few seconds for your PC or Mac to recognize the USB sound stick. The PC/Mac
will automatically set the USB sound stick as the default sound playback device.
Note: On some systems, the default sound playback device may not change to the USB
sound stick automatically. Please refer to Appendix A: Setting USB Sound Stick as
Default Sound playback device, for instructions on how to set the USB sound stick as the
default sound playback device.
The sound stick's Activity LED (Green) blinks rapidly as it connects to the
headphones. It might take up to 30 seconds for the sound stick to connect to the
headphones. Once connected, the activity LEDs on both the sound stick and the
headphones start blinking slowly.
13