LG V-C4B43NT - Manual (Page 6)

How to plug in and use
Pull out the mains lead to the desired length
and plug into the socket.
Press button (17) to start the vacuum cleaner.
To stop it press the button (17) again.
Adjusting the power level
(depending on model)
• Suction capacity increases steplessly up
to MAX.(19)
• The flexible hose handle (20) has a
manual air flow regulator (21) which
allows you to briefly reduce the suction level.
Carrying and storage
When you have switched off and unplugged
the appliance, press on the button (18) to
automatically rewind the cord.
• Use stowage clip as shown when storing
the cleaner (22).
Changing the dust bag
The dustbag needs changing when the cleaner
is set to maximum power and the cleaner head
is off the floor but the “bag full” indicator
window (23) is completely coloured red.
Even if the dustbag does not appear to be
full at this stage, it should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
• Turn off the appliance and unplug it.
• Remove hose.
• Open the cover (24)
Your appliance is equipped with either a
paper dust bag or a fabric dust bag (28)
(depending on model)
• Push the lever forwards in the direction of
the arrow (26), and pull off the full paper
filter bag towards the rear. Remove the
bag and throw it away.
• Insert the new paper filter bag into the unit
with the arrow pointing downwards (27).
If your appliance is fitted with a fab-
ric dust bag follow the same instructions
as above.
Empty it and reuse it (28). Do not wash it.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not
fitted correctly.
Cleaning the motor filter
The motor filter is situated inside the
appliance between the dust bag and the
motor. Each time that you change the air
outlet filter we advise you to remove the
motor filter (29) and to clean it by tapping to
remover the dirt and then replacing it in the
vacuum cleaner.
Check that the appliance is correctly plugged
in and that the electrical socket is working.
• Stop the appliance and unplug it.
• Check that the tubes, flexible hose and
cleaning tool are not blocked.
• Check that the dust bag is not full.
Replace if necessary.
- 5 -
What to do if your appliance
does not work
What to do when the suction
performance reduces?
Changing the air outlet filters
Depending on the model you have chosen
your appliance is equipped with different
types of filters : foam filter or electrostatic
r(35
• To change these filters remove the cover
of the filter compartment(34) situated at
the rear of the appliance.
•
The foam filter
should be cleaned
regularly by tapping it to remove the dirt.
•
• Wash the washable HEPA filter with water
at least once a year.
.
• Attention: Please don't put your finger into
the gap when you close the cover.