HP ProLiant DL380 Server - Manual (Page 29)

Operations 29
7. Secure the full-length expansion board retainer.
8. Install the access panel (on page 23 ).
9. Install the server into the rack (" Installing the server into the rack " on page 35 ).
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server (on page 21 ).
Remove the air baffle
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
1. Power down the server (on page 21 ).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend or remove the server from the rack (" Extend the server from the rack " on page 21 ).
4. Remove the access panel (on page 22 ).
CAUTION: Do not detach the cable that connects the battery pack to the cache module.
Detaching the cable causes any unsaved data in the cache module to be lost.
IMPORTANT: It is necessary to remove the PCI riser cage only if there is a full-length expansion
board installed.