Aiphone KC-IFA User Manual

Kc-ifa, Network video interface adaptor

Advertising
background image

KC-IFA

Network Video Interface Adaptor

KCS-IFA Set includes:

KC-IFA, KC-DAR, PS-2420UL

- INSTRUCTIONS -

The KC-IFA is a network video interface adaptor that allows the Aiphone color video door station to be connected
through a video server (not supplied by Aiphone) to any PC connected to a LAN or WAN network. This provides
audio and video identification and access control for a person at the camera location, answered from a PC.

DOOR STATION INSTALLATION:

1. The KC-DAR should be mounted between 48-52" above finished floor, or at optimum height for the application.
(See illustrations below.)
2. Install KC-DAR to 1-gang box or ring, or directly to wall surface with appropirate hardware.
3. Use 2 conductor, 18AWG non-shielded wire from KC-DAR to KC-IFA. (Aiphone #871802)

Single-gang box

83.5mm

(3-5/16")

Back frame

Screws supplied (2)

KC-DAR

Tamperproof
screw & cover

Mounting height

250cm (8'3")

130cm (4'3")

50cm

(20")

Unit
center

150cm (5')

The KCS-IFA System interfaces with a Network Video Server.
Aiphone has evaluated and approved the following manufactures’ products for use with the KC-IFA:

BRAND:

MODEL:

NOTES:

Inscape Data

NVS-410

Two relay outputs (One for door release)
Software Included

http://www.inscapedata.com/pdf/nvs410.pdf

VCS

VIP 10

One relay output for door release

http://www.controlware.de/cwp/daten/PDFs/Datenblatt_VIP10.pdf

NOTE: RS232 programmable relay controller can be interfaced with most video servers to control
The Tilt function of the video door station. Contact Technical Support for more information.

VIP10

NVS-410

TERMINAL DEFINITIONS:
A1/A2:

KC-DAR Connection

+/-:

DC 24V Input

BNC Connector: Video Output
NO,NC,COM: Call-in Output
OUT/GND:

Audio Output

IN/GND:

Audio Input

UP:

Tilt Control Up (“Lo” active)

DN:

Tilt Control Down (“Lo” active)

GND:

Tilt Control Ground

SPECIFICATIONS:
Power Source:

24VDC, 1A

Consumption

400mA, Max.

Video Out:

NTSC, 1Vp-p

Audio In:

10k Ohm

Audio Out:

600 Ohm

Call-in Signal:

N/O – COM – N/C, 24V DC@ 1A
(Present at .5 sec.; adjustable to 30 sec.)

Tilt Up/Down:

TTL/CMOS low level control

Weight:

4.3 lbs

Dimensions:

1.7"H x 7.9"W x 9"D

KC-DAR to KC-IFA:

2 parallel wires, non-polarized (#871802)
22 AWG = 165', 18 AWG = 330'

Pg. 1

Advertising