HP Smart Update Manager (User Guide) - Manual (Page 10)

Supported Component
No SAS and SATA hard drive firmware behind non-Smart
Array controllers
Yes Emulex, QLogic, and Brocade Fibre Channel HBA firmware
Yes Tape Blade firmware
Yes, online only OA firmware
Yes, online only VC firmware
Yes CPLD firmware
Yes HP StorageWorks MDS 600 enclosure firmware
No MSA 2000 firmware (P2x00 firmware)
Yes, when attached through a Smart Array controller D2600/D2700 firmware
Yes, online only 3Gb/s and 6 Gb/s SAS BL switches
Yes FCoE/CNAs
Yes SES firmware
Deploying HP Integrity Smart Update Firmware bundles with HP SUM
You can use HP SUM to deploy components delivered with the HP Integrity Smart Update Firmware
bundles, or use HP SUM to pull updates from the web.
Deploying firmware to the HP Integrity servers is done remotely and is the same as deploying other
firmware, such as OA, with the following exceptions:
•
Specify the IP address of the Monarch (primary) OA on Superdome 2 enclosures, or the
Monarch iLO 3 management processor on multi-blade servers.
•
On the Select Components screen, click Configure Now, and then select whether you want to
Upload and Activate or Upload but Do Not Activate. The Upload and Activate option
automatically powers down and reboots the server after the update finishes, which activates
the firmware. If you select the Upload but Do Not Activate option, the server does not
automatically reboot, so you must either manually reboot or wait for the next regularly-scheduled
maintenance reboot for the firmware to be activated. By default, HP SUM selects Upload but
Do Not Activate.
For more information on HP Integrity Smart Update Bundles, see the Manage HP Integrity Servers
Firmware Updates website at
www.hp.com/go/smartupdate/integrity
HP SUM supported firmware for Integrity servers
Supported Component
Yes Online System ROM firmware
Yes FPGA firmware
Yes iLO-3 MP firmware
Yes Power Monitor firmware
Yes Superdome 2 Complex and nPartition firmware
Yes OA firmware
Yes VC firmware
Yes (Integrity servers running HP-UX) IO Card firmware
10 Introduction