LitterMaid LM680 - Manual

Quick Start Guide
No Tools Required for Setup
Self-Cleaning Litter Box
1. Unpack pieces: LitterMaid ® scoop and rake cleaner,
litter box, AC adapter (in paper pulp), disposable waste
receptacles, Use & Care manual and cleaning brush (packed
with disposable waste receptacles), plus any optional items
including the carbon filters, paw-cleaning ramp and litter box
carpet.
2. Cut and remove the restraints
on each end of the rake.
3. Peel off protective tape
on the waste receptacle
compartment cover and the
battery compartment. Remove
paper pulp on top of the rake.
Note: Battery compartment
takes 8 "AA" cell batteries.
(Batteries not included).
Important: Do not mix old and new batteries. Do not mix
alkaline and carbon-zinc (standard) batteries. Do not use
rechargeable type (Ni-Cad, Ni-MH or Li-lon) batteries.
Installing Waste Receptacle:
Note: Unit comes with initial
waste receptacle installed.
4. Place a disposable waste
receptacle under the waste
receptacle compartment cover.
Make sure that the front of the
waste receptacle is under the
five tabs. There should be no
gap between the unit and the
waste receptacle.
5. Attach the waste receptacle
lid by inserting the pushtabs
into the round holes. To secure,
press on the positions indicated.
Installing Carbon Filters:
6. Peel off the paper strip
on the carbon filter to expose
the adhesive. Place filter
adhesive-side down in the
diamond-shaped insert in the
center of the waste receptacle
lid; close waste receptacle
compartment cover.
7. To fill the unit, use only a hard clumping litter. Do not
use non-clumping litter, crystal or pearl-like litters. Fill the
LitterMaid ® litter box to just below the “Max Line.”
8. Use the LitterMaid ® scoop and
rake cleaner to check that the
litter is at the correct level in the
center of the unit. Do not overfill
the unit or it will not operate
properly.
9. Remove the AC adapter from
the paper pulp and plug it into
the unit.
10. Plug the cord into a standard electrical wall outlet.
11. Press the On/Off button
to "on" and a green light will
appear.
12. The removable rake will
automatically run through its first
cleaning cycle and will smooth
out litter.
Your LitterMaid ® litter box is now
ready to use!
Note: Refer to the Use & Care
manual for further instructions
on the removal and cleaning of
the rake.
If your unit is not working properly, please refer to
TROUBLESHOOTING in the Use & Care manual.
If you need to acclimate your cat to the LitterMaid ® litter
box, refer to ACCLIMATING YOUR CAT in the Use & Care
manual.
Optional Items:
For more information, call: Toll-Free 1-800-LITMAID
(548-6243).
Or, visit our website: www.littermaid.com
Litter box carpet: Place the unit on the litter box carpet.
Cat Paw-cleaning Ramp:
13. The paw-cleaning ramp has
two holes that snap into the
pivot pins on the inside of the
waste receptacle compartment
cover. Position the paw-cleaning
ramp with carpet-side facing up.
14. Point the pivot pins toward the disposable waste
receptacle end of the unit. Lift the paw-cleaning ramp and
insert one of the pivot pins into one of the holes.
15. Slightly stretch the other pivot pin to reach the other hole,
then insert. Tug slightly on the paw-cleaning ramp to ensure
that it is firmly in place.
Removing Disposable Waste Receptacle:
Important: We recommend avoiding contact with waste
material. Wear rubber or latex gloves when handling
used disposable waste receptacle.
16. Depress the two pushtabs
in the waste receptacle
compartment cover. Detach
the disposable waste receptacle
lid from the waste receptacle
compartment cover.
17. Lift the compartment cover, exposing the closed
disposable waste receptacle assembly.
18. Pull the disposable waste receptacle edge free from
the tabs holding it in place.
19. To dispose of the waste
receptacle, press in on four
corners of lid to secure lid
to the waste receptacle and
dispose.
R22008/3-25-103E Printed in People’s Republic of China.
®
Model LM680
Use only hard clumping litter.
AC A DAP TER
▼ Max
Line ▼