Ampeg B500DR - Manual (Page 8)

P/N 47-697-01 • 073004
Ampeg reserves the right to change specifications without notice.
Made with Pride in the U.S.A. by Ampeg • ©2004 Ampeg, 1400 Ferguson Avenue, St. Louis, MO 63133 U.S.A.
Technical Specifications
System Block Diagram
OUTPUT POWER RATING 500 Watts @ 2 Ohms
350 Watts @ 4 Ohms
TONE CONTROL RANGE Bass: 16dB range @ 50Hz
Ultra Mid: +6dB @ 600Hz, -9dB @ 350Hz
Treble: 31dB range @ 5kHz
Ultra High: +8dB @ 10kHz
Ultra Low: +7dB @ 40Hz
SIGNAL TO NOISE RATIO 75dB typical
POWER REQUIREMENTS 120VAC, 60Hz, 545VA
100-120VAC 50/60Hz, 545VA
220-240VAC, 50/60Hz, 545VA
SIZE AND WEIGHT 19”W x 3.8”H (with feet) x 15.5”D; 32 lbs
www.ampeg.com
B500DR Programmable Bass Amplifier
INPUT
INPUT
1
INPUT
2
LIMIT
LED POWER
AMP PROTECTION
RELAY
SPEAKON ®
JACK
SPEAKER
OUTPUT
1+
1-
SPEAKER
OUTPUT
POWER
AMP IN
PREAMP
OUT
EFFECTS
RETURN
EFFECTS
SEND
THERMAL
SHUTDOWN,
LOW VOLTAGE,
DC PROTECT
COOLING
FAN
BALANCED
LINE OUT
POST
PRE
MASTER
FX BLEND GAIN
PEAK LED
LEVEL
BASS TREBLE ULTRA MID
ULTRA LOW PAD
LIMIT
DEFEAT
ULTRA HIGH
Declaration of Conformity
Manufacturer’s Name: SLM Electronics
Corporate Headquarters: 1901 Congressional Drive, St. Louis, Missouri 63146
Primary Production Facility: 700 Hwy 202 W, Yellville, Arkansas, 72687
Product Type: Audio Amplifier
Products meet the regulations for compliance marking under:
ETL standards UL6500, UL60065, or UL813
CSA standards E60065 or C22.2 No.1-M90
CE safety standard EN60065
CE EMC standards EN55103 or EN55013 and EN61000
FCC standards 47CFR 15.107 and 15.109 Class A
C-tick designation Level 2, ABN #56748810738, ARBN# N222
KETI standard K60065 (limited model approval)
Compliance Support Contact: SLM Electronics, Attn: R&D Compliance Engineer
1901 Congressional Drive, St Louis, Missouri, 63146 • Tel.: 314-569-0141, Fax: 314-569-0175