HP Neoware e140 Thin Client - Manual (Page 401)

C-31
Host Command Summary
BQ 3107 Emulation
CHARACTER DISPLAY
Blank area rendition ~
Blink area rendition ^
Select graphic rendition ESC [ * ; * ; * m
Select G0, national or ASCII character set SI
Select G1 graphic symbols character set SO
Select G2 accented characters and special symbols set ESC E
CURSOR
Cursor addressing (1 to 80 = SP to g DC3 *line *column
Cursor position is end of next transmitted text ESC U
Cursor position is start of next transmitted text ESC T
Cursor On (* = 0) or Off (* = 1) ESC [ * r
Move cursor to left margin of current line CR
Move cursor one column left BS
Move cursor one column right DC2
Move cursor to begining of partition or field DC4
Move cursor down one line LF
Move cursor up one line DC1
Move cursor to next tab stop HT
Set tab stop ESC 1
Cancel tab stop ESC 2
ERASE
Active partition erasure FF
Erase in field (0 = from cursor, 1 = to cursor, 2 = all) ESC [ * N
Erase in line (0 = from cursor, 1 = to cursor, 2 = all) ESC [ * K
Erase in partition (0 = from cursor, 1 = to cursor, 2 = all) ESC [ * J
FIELDS
Start of a fixed field FS
Start of a variable field GS *
Repeat fields RS X
GENERAL
Buffer character repetition (* = @ to DEL) US *
Define area qualification ESC [ * o
Format mode ESC M
Normal mode ESC N
Message waiting ESC R
Set mode (? = SDP mode, ? < extended mode) ESC [ ? = ; ? < ; ? 0 h
Reset mode (? = VIP mode, ? < 94 character mode) ESC [ ? = ; ? < ; ? 0 l
Reset both partitions ESC c
Select current partition (0 = partition 0, 1 = partition 1) ESC [ * v
Warning (bell) BEL