HP Storage Mirroring V5 Software - Manual (Page 157)

11 - 23
14. If you need to clear the monitor settings so that they can be reconfigured, use the monitor clear command.
15. If you need to delete an established monitor, use the monitor delete command.
Testing failover
Verify that the source machine is offline and not connected to the network to avoid IP address conflicts and trigger failover
using the
failover command.
Command MONITOR CLEAR
Description Clears all of the failover configuration and monitoring parameters for the specified monitor
machine
Syntax MONITOR CLEAR [ monitor ]
Options monitor —Name of the source machine designated as the monitor
Examples monitor clear indy
Notes ‹ If you do not specify a monitor, the current source designated as the monitor will be used. If you
have not identified a monitor, you will receive an error message stating that a monitor has not
been selected.
‹ Machine names that contain non-alphanumeric characters must be enclosed in quotation marks.
Command MONITOR DELETE
Description Deletes the specified failover monitor and all of its parameters
Syntax MONITOR DELETE < monitor >
Options monitor —Name of the source machine designated as the monitor
Examples monitor delete indy
Notes Machine names that contain non-alphanumeric characters must be enclosed in quotation marks.
Command FAILOVER
Description Manually initiates the failover process for the specified monitor machine
Syntax FAILOVER < monitor > [ON < target_machine >]
Options ‹ monitor —Name of the source machine designated as the monitor
‹ target_machine —Name of the target machine
Examples failover indy on jersey
Notes Machine names that contain non-alphanumeric characters must be enclosed in quotation marks.