Unloading the io accelerator driver, Uninstalling the io accelerator driver rpm package, Disabling auto attach – HP MSR Encryption Accelerators User Manual
Page 38: Disabling, Auto attach
Maintenance 38
IMPORTANT:
All commands require administrator privileges. To run the commands, log in as
root or use sudo.
IMPORTANT:
If you came to this section from the Software Installation section, return to that
section after you uninstall previous versions of the driver and utilities.
Unloading the IO Accelerator driver
Unload the IO Accelerator driver:
$ modprobe –r iomemory_vsl
Uninstalling the IO Accelerator driver RPM package
Versions 1.2.x
Remove prior versions of the IO Accelerator software:
$ rpm -e iodrive-driver
Versions 2.x.x
With version 2.x.x of the IO Accelerator, you must specify the kernel version of the package that you are
uninstalling.
Find the installed driver packages:
$ rpm -qa | grep -i iomemory
Sample output:
iomemory-vsl-2.6.18-194.el5-2.2.2.82-1.0
For example, to uninstall the IO Accelerator (specifying the kernel version of the driver you wish to uninstall):
$ rpm -e iomemory-vsl-2.6.18-194.el5-2.2.0.82-1.0
Uninstalling the IO Accelerator Utilities, IO Accelerator
Management Tool 2.x, and other support packages
Uninstall the support RPM packages (adding or removing package names as needed):
$ rpm -e fio-util fio-snmp-agentx fio-common fio-firmware iomanager-gui
iomanager-jre libfio libfio-doc libfusionjni fio-sysvinit fio-smis fio-snmp-mib
libfio-dev
To uninstall the support DEB packages, (adding or removing package names as needed):
$ dpkg -r fio-util fio-snmp-agentx fio-common fio-firmware iomanager-gui
iomanager-jre libfio libfio-doc libfusionjni fio-sysvinit fio-smis fio-snmp-mib
libfio-dev
Disabling auto attach
When the IO Accelerator driver is installed, it is configured to automatically attach any devices when the
driver is loaded. When necessary, disable the auto_attach feature.