HP XP P9000 Command View Advanced Edition Software - Manual (Page 234)

Figure 7 Alert settings and volume reversal
Alerts set for copy group CG1 are not valid for the copy group CG1 with reversed primary and
secondary volumes. If you reverse the primary and secondary volumes for copy group CG1, the alerts
set for copy group CG1 become valid once again.
NOTE:
When primary and secondary volumes are reversed, the copy group name is the same both before
and after the reversal. However, the object ID for the copy group changes and duplicate copy groups
with the same name are displayed in the list of copy groups.
Advanced operations and corresponding P9000 RAID Manager commands
The following table lists the advanced operations available on the 3. Select Pair Operation page of
the Change Pair Status Wizard, along with the corresponding P9000 RAID Manager commands.
P9000 RAID Manager
Description
Change Pair Status Wiz-
ard
Option Command Option Operation
n/a
horctakeover -S
Performs S-VOL takeover. None
takeover
-t timeout
Specifies a timeout value for an S-
VOL takeover. Timeout for
data transfer
n/a horctakeover -l Performs P-VOL takeover. None force-split
n/a 1. pairsplit
2. pairresync -
swaps
Redirects copying, retaining the
current copy pair state.
None
swap
-c size Copy Pace
n/a
pairresync -swaps
Recovers an S-VOL from the
Split(SSWS) status and the P-VOL
and S-VOL to the Pair(PAIR) status. None takeover-re-
covery (re-
sync)
-c size Copy Pace
Managing pair life cycle 234