Tool definition configuration, Additional configuration requirements – HP Remote Insight Lights-Out Edition II Board User Manual
Page 23
Installation 23
Changes to this configuration file take effect only after performing the following operations:
1.
Stop the respective processes using the
OVSTOP
command.
2.
Start the respective processes using the
OVSTART
command.
CAUTION:
Do not modify the CPQCONFIG.DAT file, except for the parameters defined in this
section.
The Discovery section of the CPQCONFIG.DAT file can be configured to define a number of discovery
and status update intervals. All comments within the Discovery section must begin with the number sign
(#).
The Discovery section has two configurable parameters:
•
Discovery Interval—The time interval, in minutes, between two successive discoveries of nodes. If no
value is specified, the internal default is used.
o
Interval between successive HP node discovery in minutes
o
Valid range: 1 to 4272
o
Default value: 30
o
DiscoveryInterval: 30
•
Rediscovery Interval Iteration—Specification of the number of rediscoveries and retries before the
integration node discovery process is considered complete for all the nodes present in the OVW
database.
o
The Rediscovery iteration number
o
Valid range: 1 to 100
o
Default value: 10
o
Re-discoveryIntervalIteration: 10
Tool Definition configuration
A Tool Definition (TDEF) file for HP Systems Insight Manager is provided with the Insight Integration. This
file provides menu definitions that enable the NNM to be launched directly from HP Systems Insight
Manager.
1.
Copy the file nnm.xml from the /hpsim directory to the HP Systems Insight Manager\tools directory
on the HP Systems Insight Manager server.
2.
Edit the TDEF file nnm.xml, perform a search, and replace the string "localhost" with the name or IP
address of your NNM server.
3.
Open a command prompt, and change to the HPSIM\tools directory.
4.
Run the
mxtool -a -f nnm.xml
command to load the new tool definition.
5.
Close the browser and log in HP Systems Insight Manager to view the new tool menus. Run the
mxtool -r -f nnm.xml
command to remove the tool definition.
Additional configuration requirements
In addition to the installation and configuration procedures noted, perform the following steps to verify
that the Insight Integration functions correctly: