HP Workstation xw8000 - Manual (Page 22)

2-6
Adaptec SCSI RAID 2120S/2200S Software User’s Guide
Creating Arrays
Before creating arrays, make sure the disks for the array are
connected and installed in your system (or enclosure). Note that
any disks with MS-DOS partitions, disks with no usable space, or
disks that are uninitialized appear dimmed and cannot be used for
creating a new array. For information on how to initialize a disk
drive, see
page 2-9 .
To create an array:
1 Shut down and reboot the system.
2 At the BIOS prompt, press Ctrl+A.
3 From the ARC menu, select Array Configuration Utility.
4 From the ACU menu, select Create Array.
5 Use the Left/Right arrow keys to select a channel.
6 Select the disks for the new array and press Insert. ACU
displays the largest usable space available for each disk. You
can use available space from multiple disks for the new array.
Note: Consult Table 2-1 on page 2-7 for the maximum
number of drives that can be used for each RAID level.
To deselect any disk, highlight the disk and press Delete.
Note: ACU cannot reliably find disks or enclosures that
were powered up after system power-up.
7 Press Enter when all disks for the new array are selected. The
Array Properties
menu displays.
If you install a controller into a system that has been powered
down, on startup the BIOS will announce the detected
configuration changes. If the controller does not consider these
changes risky it will present a confirmation prompt and will auto-
confirm if there has been no operator input in 30 seconds. If the
controller considers that the changes are risky, you will be
prompted for further action.
UG.book Page 6 Saturday, October 26, 2002 12:08 PM