HP Integrity NonStop J-Series - Manual (Page 58)

SDR Monitoring and Control
HP NonStop SQL DDL Replicator User’s Guide —545799-007
5-6
Updater-level Command
In the following example, STATUS UPDATE shows the SDR updater is in a HOLD
state, RESTART UPDATE is used to stop it and restart it and the subsequent STATUS
UPDATE shows the updater executing:
Updater-level Command
As mentioned in paragraph SDR Updater Processes on page 4-8, an SDR updater
manages one RDF configuration or RDF control subvolume. This is why SDR updater
commands operate on a single SDR updater process, identified by the RDF control
subvolume associated with this SDR updater.
HOLD RDF-control
RELEASE RDF-control
EXECUTE RDF-control
CANCEL RDF-control
SDRCOM 60? STATUS UPDATE
SDR monitor $ZSDR (5,627) is monitoring 1 RDF environment(s).
Current SDRUPDT processes: 1
Total SDRUPDT processes: 8
RDF Control Subvol ATOMJ
SDR Updater Process \SIERRA.$X8LB (3,410)
RDF Primary Sys \ATOM
RDF Backup Sys \SIERRA
State Updater executing (Update HOLD)
*** This updater is in HOLD state. ***
SDR Operation Count Failed
SDRDEPOT fetch 0
DDL translation 0
SQL process start 0
DDL execution 0
RDF update restart 0
No replications performed by this SDR updater.
SDRCOM 61? RESTART UPDATE
Restarting SDR updater ATOMJ with HOLD OFF.
SDRCOM 62? STATUS UPDATE
SDR monitor $ZSDR (5,627) is monitoring 1 RDF environment(s).
Current SDRUPDT processes: 1
Total SDRUPDT processes: 9
RDF Control Subvol ATOMJ
SDR Updater Process \SIERRA.$X8MZ (4,379)
RDF Primary Sys \ATOM
RDF Backup Sys \SIERRA
State Updater executing
SDR Operation Count Failed
SDRDEPOT fetch 0
DDL translation 0
SQL process start 0
DDL execution 0
RDF update restart 0
No replications performed by this SDR updater.