HP Integrity NonStop J-Series - Manual (Page 103)

Command Interpreter
HP AutoSYNC User’s Guide—522580-017
8-9
ADD SYNCFILESET
src-file-set
a file set on the local system that is the source of the synchronization operation. If
a system name is specified, it must be the local Expand node name.
dest-file-set
the location of the file set that is to be updated.
The volume, subvolume, and filename portions of a destination file set must be
either asterisk (*) or must be fully specified. For each part of the source file set that
has a trailing asterisk (*), the corresponding part of the destination file set must be
asterisk (*).
A dollar-sign asterisk ($*) is not a valid destination volume; use asterisk (*) instead.
The destination system may be specified as back slash asterisk (\*), which implies
synchronization to every destination system that has AutoSYNC installed, licensed,
and running.
Using backslash asterisk (\*) for the destination system is not supported for OSS
file sets or for file sets configured for synchronization over TCP/IP.
Guardian file set definition
Source file sets can take the following forms:
°
Fully qualified: for example $a.b.c
°
Partially qualified: for example $a.b*.c*"
°
"*": for example $a.b.*
Rules:
A fully qualified source file set can be synchronized to a fully qualified destination
file set or to a destination file set specified as "*".
Partially qualified or "*" source file set must be synchronized to a destination file
set specified as "*".
OSS-only-options:
{ ALLHARDLINKS | NO ALLHARDLINKS }
{ ALLSYMLINKS | NO ALLSYMLINKS }
{ OWNERG[ROUP] { group-id | group-user } }
{ SECURE “rwxrwxrwx” }