HP Compaq t5710 Thin Client - Manual (Page 69)

6-9
Setup Menus
Making A Network Host Connection
To connect to a network host node, select TCP/IP in the Type list box. The Connect
To box will display the available devices on the network. Select the name of the device
required or enter the host name or IP address. If the session was created using the
Connection Wizard and the Host Rollover On Connection Fail option was selected,
you can specify up to three more hosts in the boxes below. The emulator will attempt
to connect to each specified host in turn until one is successful.
Clicking the Telnet Options button will display a dialog box with additional options.
These are described in the Getting Started chapter.
Clicking the Connect button or the name of the host in the Connect To list box twice
will cause the emulator to attempt to connect to the specified host. If a connection
cannot be made because the network driver is not installed or the host node name is
invalid, an error message will indicate this. Failure to connect for any other reason will
result in a Connection Failed message.
Open Session...
(Not available in WBT mode)
This enables you to select a connection template. The following dialog box will be
displayed.