HP Deskjet 3050A - Manual (Page 10)

Light behavior Solution
Off ePrint is disabled. Press ePrint button to access ePrint
menu on the printer display.
On ePrint is on and connected.
On Button Light
Light behavior Solution
Off The device is powered off.
Pulsing Indicates the device is in sleep mode. The device
automatically enters sleep mode after 5 minutes of
inactivity.
Fast blinking Error has occurred. Refer to messages on printer display.
On Printer is on and ready to print.
Auto Power-Off
Auto Power-Off is automatically enabled by default when you turn on the printer. When Auto Power-Off is enabled, the printer
automatically turns off after 2 hours of inactivity to help reduce energy use. Auto Power-Off is automatically disabled when
the printer establishes a wireless or Ethernet (if supported) network connection. You can change the Auto Power-Off setting
from the control panel. Once you change the setting, the printer maintains the setting. Auto Power-Off turns the printer off
completely, so you must use the power button to turn the printer back on.
To change Auto Power-Off setting
1. From the Control Panel home screen, which displays Copy, Scan, and Quick Forms, press the Setup button.
NOTE: If you do not see the home screen, press the Back button until you can see it.
2. From the Setup menu on the printer display, select Auto Power-Off.
3. From the Auto Power-Off menu select Enabled or Disabled, and then confirm the setting.
TIP: If you are printing over a wireless or Ethernet connected network, Auto Power-Off should be disabled to ensure that
print jobs do not get lost. Even when Auto Power-Off is disabled, the printer enters Sleep mode after 5 minutes of inactivity
to help reduce energy use.
Chapter 2
8 Get to know the HP All-in-One