Traditional wireless connection, Usb connection – HP Deskjet 3050 User Manual

Page 38

Advertising
background image

❑ Enter the PIN on WPS-enabled router or other networking device.
❑ Follow the on-screen instructions on the printer display.

NOTE:

The product begins a timer for approximately two minutes in which the

PIN needs to be entered on the networking device.

2.

View the animation for this topic.

Traditional Wireless Connection

To connect the HP All-in-One to an integrated wireless WLAN 802.11 network, you will
need the following:
❑ A wireless 802.11 network that includes a wireless router or access point.

If you connect the HP All-in-One on a wireless network that has Internet access, HP
recommends that you use a wireless router (access point or base station) that uses
Dynamic Host Configuration Protocol (DHCP).

❑ A desktop computer or laptop with either wireless networking support, or a network

interface card (NIC). The computer must be connected to the wireless network that
you intend to install the HP All-in-One on.

❑ Network name (SSID).
❑ WEP key or WPA Passphrase (if needed).

To connect the product

1.

Insert the product Software CD in the computer CD-ROM drive.

2.

Follow the instructions on the screen.
When you are prompted, connect the product to the computer using the USB setup
cable included in the box. Follow the onscreen prompts to enter your wireless network
settings. The product will attempt to connect to the network. If the connection fails,
follow the prompts to correct the problem, and then try again.

3.

When the setup is finished, you will be prompted to disconnect the USB cable and
test the wireless network connection. Once the product connects successfully to the
network, install the software on each computer that will use the product over the
network.

USB Connection

The HP All-in-One supports a rear USB 2.0 High Speed port for connection to a computer.

To connect the product with the USB cable

Refer to the setup instructions that came with your product for information on
connecting to a computer with a USB cable.

NOTE:

Do not connect the USB cable to the product until you are prompted to

do so.

To enable printer sharing on a Windows computer

Refer to the user guide that came with your computer or see the Windows onscreen
Help.

Chapter 7

36

Connectivity

Connectivity

Advertising
This manual is related to the following products: