HP Integrity NonStop H-Series - Manual (Page 29)

Installation and Basic Management
HP NonStop AutoTMF Software User’s Guide—429952-013
2-9
Install EMS templates
You should start the monitor process after TMF has been started but before starting
Pathway or any application processes. Start the NonStop AutoTMF monitor process by
using the following TACL command:
The user ID required to start the monitor also must have read access to SysDB and
MapDB tables.
Install EMS templates
The file ZESCTMPL contains EMS templates for all events generated by the NonStop
AutoTMF software. Please refer to the DSM Template Services Manual for instructions
about installing system templates.
You can use the EMS filter file ESCFLTR with an EMS distributor to display NonStop
AutoTMF events.
Updating NonStop AutoTMF Software
1. Stop application programs and all processes that use the NonStop AutoTMF
runtime library. In this case, display (and optionally stop) all programs that use the
NonStop AutoTMF runtime library by using the
INFO LIBRARY command.
2. Stop the NonStop AutoTMF monitor process by using the command STOP
MONITOR .
3. Replace the NonStop AutoTMF software files as described above under Install
NonStop AutoTMF Software Files .
4. If required, bind your application user libraries with the new NonStop AutoTMF
runtime library. See Combining a User Library with the NonStop AutoTMF Runtime
in Section 3, Preparing Programs .
5. If you need to preserve modification timestamps or preserve license attributes of
object files when preparing programs, perform the necessary steps to make the
new Escort CI a licensed program, as described in
Preserving the Modification
Timestamp of Object Files or in Preserving License Attribute when Preparing
Privileged Programs in Section 3, Preparing Programs .
6. Install the new NonStop AutoTMF EMS templates.
7. Restart the NonStop AutoTMF monitor process.
8. Restart the application programs.
RUN $SYSTEM.ESCORT.ESCORT START MONITOR;