Adding copy pairs (completed workflow), Relationship between, Managed resources and memory heap size – HP XP Array Manager Software User Manual
Page 178
•
The startup mode values of BCM Agent initialization parameters must be set to EDIT (default value
is MONITOR). If a configuration definition is updated or copy pair status is changed when the
startup mode value is MONITOR, a BCM Agent error will occur.
TIP:
If you want to use an IPv6 connection or SSL communication between Replication Manager and BCM,
IHS must be set up. For details about setting up IHS, refer to the HP StorageWorks P9000 for Business
Continuity Manager Software documentation.
Relationship between managed resources and memory heap size
It is necessary to set an appropriate memory heap size, depending on the maximum number for each
resource. For details on the number of managed resources supported and how to change the memory
heap size, see the HP P9000 Replication Manager Software Configuration Guide.
Adding copy pairs (completed workflow)
After completing the initial pair configuration, you can add additional copy pairs to a copy pair
configuration definition. This can be done only if the associated task is not in successful status (such
as when the associated task is in execution ready status or has failed). You can edit the completed
workflow created upon completion of the Pair Configuration Wizard.
To add copy pairs to a completed workflow:
1.
In the Explorer menu, choose Tasks and then Tasks.
A list of tasks is displayed in the Tasks subwindow.
2.
Select the task associated with the pair configuration you want to edit.
3.
Click Cancel Tasks.
4.
Confirm the cancel operation in the confirmation dialog and cancel the task.
The task is displayed in the Tasks subwindow with Cancel status.
5.
Select the canceled task and click Delete Tasks.
6.
Confirm the delete operation in the confirmation dialog and delete the task.
7.
In the Explorer menu, choose Tasks and then Workflows.
A list of workflows is displayed in the Workflows subwindow.
8.
Select the workflow associated with the pair configuration you want to edit.
9.
Click Edit Workflows.
The Pair Configuration Wizard is launched. The page on which the selected workflow was saved
is displayed.
10.
Click Back until you reach the 2. Pair Association page.
11.
Define new copy pairs and complete pair configuration.
Related topics
Managing pair life cycle
178