Editing copy groups by associating new pair groups – HP XP Array Manager Software User Manual
Page 179
Editing copy groups by associating new pair groups
To edit an existing copy group by associating new pair groups:
1.
In the Hosts view, Storage Systems view, or Pair Configurations view, display information about
the copy group for which you want to edit the copy pair configuration definition.
For details on the Hosts view, Storage Systems view, and Pair Configurations view, see the
following:
•
•
Viewing a list of storage systems
•
Viewing a list of copy pair configurations
2.
In the displayed subwindow, select a copy group. Alternatively, make sure that copy group
information is displayed, and then click Pair Management.
The Pair Configuration Wizard starts with the 1. Introduction page displayed.
3.
Read the wizard page, and then click Next.
The 2. Pair Association page appears. The copy topology (configuration of the related copy
groups) to which the copy group belongs is displayed in the Copy Topology pane.
4.
Create a pair group in the Copy Topology pane.
5.
Define a list of copy pairs that you want to include in the pair group, by selecting the primary
and secondary volumes in the Candidate List pane. For details on how to define copy pairs, see
“
Creating pairs and pair groups
The defined copy pairs are displayed in the Pair List pane.
6.
Repeat steps 4 and 5 to create additional pair groups.
You can click the
icon or the
icon to expand the Candidate List and Pair List display
areas.
7.
Click Next.
The 3. Group Management page appears.
8.
Select the copy group you want to edit and the pair group to be associated with the copy group,
and then click Apply.
The pair group registered on the 2. Pair Association page is assigned to the copy group.
9.
Click Next.
The settings specified in the above steps are listed as tasks that correspond to copy groups on
the 4. Task Management page.
10.
Click Next.
The 5. Confirm page appears.
11.
Confirm the configuration definition and tasks for the copy pairs you have specified, and then
click Confirm.
The 6. Finish page appears.
12.
Click Finish.
The settings specified in the wizard are registered as tasks and a workflow. If a workflow was
temporarily saved earlier because it was incomplete, that workflow is overwritten.
User Guide
179