HP OFFICEJET 4500 - Manual (Page 57)

you are trying to send a fax to another country/region or receive a fax from another
country/region, or if you are using a satellite phone connection.
To set the fax error-correction mode
1. Press Setup.
2. Press right arrow to select Fax Settings, and then press OK.
3. Press right arrow to select Error Correction, and then press OK.
4. Press right arrow to select On or Off, and then press OK.
Set the dial type
Use this procedure to set tone-dialing or pulse-dialing mode. The factory-set default is
Tone. Do not change the setting unless you know that your phone line cannot use tone
dialing.
NOTE: The pulse-dialing option is not available in all countries/regions.
To set the dial type
1. Press Setup.
2. Press right arrow to select Basic Settings, and then press OK.
3. Press right arrow to select Tone or Pulse, and then press OK.
4. Press right arrow to select the appropriate option, and then press OK.
Set the redial options
If the device was unable to send a fax because the receiving fax machine did not answer
or was busy, the device attempts to redial based on the settings for the busy-redial and
no-answer-redial options. Use the following procedure to turn the options on or off.
•
Busy redial: If this option is turned on, the device redials automatically if it receives
a busy signal. The factory-set default for this option is ON.
• No answer redial: If this option is turned on, the device redials automatically if the
receiving fax machine does not answer. The factory-set default for this option is
OFF.
To set the redial options
1. Press Setup.
2. Press right arrow to select Fax Settings, and then press OK.
3. Press right arrow to select Redial Options, and then press OK.
4. Press right arrow to select the appropriate Busy Redial or No Answer Redial
options, and then press OK.
Set the fax speed
You can set the fax speed used to communicate between your device and other fax
machines when sending and receiving faxes.
Change fax settings 53