HP 3PAR Operating System Software - Manual (Page 13)

Configuring Networking
Enter the name and IP address information for your new HP 3PAR StoreServ Storage system.
For more information, see your completed Storage System Software Installation Checklist from the
HP 3PAR StoreServ 7000 Site Planning Manual.
Configuring Your Time Zone
You can:
•
Copy the time zone settings from the Service Processor to the HP 3PAR StoreServ Storage
system
•
Enter a specific date and time
•
Use the date and time settings on your NTP server, if applicable
•
Select your continental region (Africa, Antarctica, Asia, Australasia, Europe, North America,
or South America) and the city or country closest to you from the drop-down lists that are
based on the tz database.
Changing the HP 3PAR StoreServ Storage System Password
Enter a new, secure password for 3paradm.
You will use this username and password to access your new HP 3PAR StoreServ Storage system.
For more information, see your completed Storage System Software Installation Checklist from the
HP 3PAR StoreServ 7000 Site Planning Manual.
Monitoring Setup Progress
The Setup system volumes operation in the Progress step can continue for up to 40 minutes before
the wizard displays a progress indicator. Do not attempt to cancel out of the wizard during the
Progress step.
Continuing SmartStart Setup
After the Storage System Setup wizard initializes the HP 3PAR StoreServ Storage system:
1. Click Finish in the Setup Progress and Results step to exit the Storage System Setup wizard.
NOTE: The wizard continues to run tests in the background after you have exited the Storage
System Setup wizard. If these tests discover any issues, the HP 3PAR Management Console
will display details in the Alert tab relevant to the issue.
•
To install the Management Console, go to SmartStart wizard Step 6, Install the
Management Console.
•
For more information on Alerts, start the Management Console and open the HP 3PAR
Management Console Online Help.
2. Set up Local Notification. For more information, see “Setting Up Local Notification” (page
14) .
3. Validate Remote Support setup. For more information, see “Validating Remote Support” (page
14) .
4. Continue to SmartStart wizard Step 3, Connect to the storage system.
Troubleshooting: Adding the Storage System to the Service Processor
If the wizard is not able to successfully add your HP 3PAR StoreServ 7000 Storage system to the
Service Processor, use the SPmaint module in SPOCC to add the storage system (using the “Add
New InServ” option) to your Service Processor.
Configuring Networking 13